Standard tremolo or bridge
- Loosen all 6 strings by unwinding at the tuning pegs.
- Place the first string through the tremolo or bridge
- Put the new string through the tuning peg hole and wrap around.
- Tighten slightly so that each string can hold itself.
- Repeat for all strings.
- Tune to pitch
- Stretch strings
- Repeat steps 6 and 7 until the guitar does not go out of tune when you play it.
Floyd Rose Tremolo
- Loosen the top nut
- Loosen the strings with the tuning machines.
- Loosen string lock bolts at the end of the bridge approximately 3 turns.
- Repeat steps 5 - 8 for each string. It is suggested that you only replace one string at a time due to the nature of the tremolo.
- Remove the old string.
- Place the new string through the tuning peg and locking nut.
- Cut the string and leave about 1 - 2 inches to work with.
- Insert the string into the bridge saddle and tighten until snug but do not overtighten.
- Repeat steps 5-8 for each string.
- Adjust fine tuning knobs to the middle position.
- Stretch strings and tune to pitch using the tuning machines on the headstock.
- Tighten the locking topnut.
- Stretch strings again
- Use fine tuning knobs to tune to pitch.
Classical Acoustic Guitar
- Remove old strings
- Tie one end of the strings to the bridge
- Put the new string through the tuning peg hole and wrap around
- Tighten slightly so that it can hold itself.
- Repeat for all strings.
- Tune to pitch
- Stretch strings
- Repeat steps 6 and 7 until the guitar does not go out of tune when you play it.
No comments:
Post a Comment